Options

选择

Mode

模式

Loop

环路

In this mode, an automatic loop recognition will be used that can be controlled somewhat using the Stop Cut At Ngon and Stop Cut At Pole options.

在这种模式下，将使用一个自动循环识别系统，可以通过在 Ngon 停止切割和在极点停止切割的选项进行一定程度的控制。

Path

路径

Without polygon or edge selections, this tool will work like the Loop mode. However, if you first select a coherent selection path, the tool will try to follow this path (starting from the edge beneath the cursor).

没有多边形或边的选择，这个工具将像循环模式一样工作。但是，如果您首先选择一个一致的选择路径，该工具将尝试遵循这个路径(从光标下面的边缘开始)。

An edge selection should look like that which the Ring Selection tool makes in Use Edge mode.

边缘选择应该看起来像环选择工具使用边缘模式。

Offset Mode
Offset[0..100%]
Distance[0..+∞m]

偏移模式偏移量[0. . 100% ]距离[0. . + ∞ m ]

The Offset Mode defines how the loop cut should react to different polygon widths:

偏移模式定义了循环切割应该如何对不同的多边形宽度做出反应:

• Proportional 比例: The cut will be made in a distance (defined by the : 切割将在一段距离内进行(定义为Offset 偏移量 value) relative to the neighboring edge 值)相对于邻近边缘
• Edge Distance 边缘距离: The cut will be made parallel to the respective edge. Each cut point will, if possible, have the exact same : 切口将平行于各自的边缘。如果可能的话，每个切点都会有完全相同的切点Distance 距离 from the next point 从下一点开始

The Offset and Distance values are calculated starting from the reference point (green point). Enable the Toggle Direction option if the cut is made from the wrong edge when Offset Mode is set to Edge Distance.

偏移量和距离值从参考点(绿点)开始计算。当偏移模式设置为边缘距离时，如果从错误的边缘进行切割，则启用切换方向选项。

Number of Cuts[1..2147483647]

削减的次数[1.2147483647]

This setting defines the number of loop cuts. This can also be done interactively in the Viewport by clicking on an orange loop cut with the MMB and dragging horizontally.

这个设置定义了循环切换的次数。这也可以在 Viewport 交互式地完成，点击一个用 MMB 切割的橙色环，然后水平拖动。

Restrict To Selection

限制选择

If enabled, only selected polygons or edges will be cut.

如果启用，只有选定的多边形或边缘将被切断。

Select Cuts

选择切割

If enabled, newly created cut lines will be selected (visible only in Use Edge mode).

如果启用，新创建的切线将被选中(仅在使用边缘模式下可见)。

Connect Cut Edges

连接切割边缘

If enabled, polygons will also be cut. Otherwise only edges will be cut.

如果启用，多边形也将被切割。否则只有边缘将被切割。