Shaping

塑形

Preserve Curvature
Tension[-5..5]

保持曲率紧张[-5. . 5]

Let’s say you want to place a loop cut on a sphere. If this option is disabled, a cut as shown at the left of the image above will be created: the cut is located on the same plane as the neighboring edges. Not exactly what one imagines for a sphere. If the option is enabled, the cut will accommodate the neighboring curvature, which results in a convexity (green line) of the cut edge. The degree to which the convexity should be calculated is defined by the Tension setting. Negative values can be used to move the curvature in the other direction. The Number of Cuts value can be increased to more precisely define the green curve’s shape.

假设你想在一个球体上放置一个环形切口。如果这个选项被禁用，一个如上图左边所示的切口将被创建: 切口位于相邻边缘的同一平面上。这可不是人们想象中的球体。如果选项启用，切口将容纳相邻的曲率，这将导致一个凸起(绿线)的切口边缘。凸度的计算程度取决于张力的设定。负值可以用来将曲率向相反的方向移动。削减数值可以增加，以便更精确地定义绿色曲线的形状。

Profile

个人资料

Enable this option if the cut or cuts should follow a specific profile and adjust the curve accordingly.

启用此选项，如果削减或削减应遵循一个特定的配置文件，并相应调整曲线。

Depth[-∞..+∞m]

深度[-∞ . . + ∞ m ]

If the profile curve corresponds to the cut’s profile, the Depth value defines the shape’s amplitude. Negative values can also be used, which will invert the curve accordingly.

如果剖面曲线对应于切割的剖面，则深度值定义形状的振幅。也可以使用负值，这将相应地反转曲线。