Polygon Extrusion

多边形挤压

The following settings are only available when beveling polygons.

下面的设置只有在斜面多边形时才可用。

A combination of Extrude and Extrude Inner is used when polygons are beveled, i.e., the polygon is brought out of its original position, scaled and moved in the direction of its Normals (or in the opposite direction, if desired).

当多边形被斜面化时，就是说，多边形被带离原来的位置，向法线的方向缩放和移动(或者向相反的方向移动，如果需要的话) ，就采用挤压和挤压内部的组合。

An example can be seen under Extrusion.

一个例子可以看到挤压下。

Extrusion[-∞..+∞m]

挤压[-∞ . . + ∞ m ]

This value defines the distance that the extruded polygon will have to its original position (in the direction of its Normals).

该值定义了挤压多边形到其原始位置(法线方向)的距离。

Max Angle[0..+∞°]

最大角度[0. . + ∞ ° ]

If Preserver Groups (see below) is enabled, polygons whose angle to one another do not exceed this value will be kept together. If the polygons’ angles exceed this value they will be separated when beveled.

如果保存组(见下文)被启用，那么相互之间的角度不超过这个值的多边形将被保存在一起。如果多边形的角度超过这个值，它们将在斜面时被分开。

Preserve Groups

保护群体

If this option is enabled, connected surfaces will not be separated when beveled - as long as the angles to another do not exceed the value defined in the Max Angle setting.

如果启用此选项，连接的表面在斜面时不会被分离——只要与另一个表面的角度不超过在最大角度设置中定义的值。