Polygon Extrusion

多边形挤压

The following settings are only available when beveling polygons.

下面的设置只有在斜面多边形时才可用。

When beveling polygons is a combination of Extrude and Extrude Inner, i.e., the polygon will be taken from its initial position, its size will be modified and moved in the direction of its normals (or in the opposite direction, if desired).

当斜面多边形是挤压和内挤压的结合，即多边形会从它的初始位置开始，它的大小会被修改，并沿着法线的方向移动(如果需要的话，也会朝相反的方向移动)。

Extrusion[-∞..+∞m]

挤压[-∞ . . + ∞ m ]

This is the distance that the extruded polygon will have from its initial position (in the direction of its normals).

这是挤压多边形将有其初始位置(在其法线方向)的距离。

Extrusion can be adjusted interactively with the mouse (see Use).

挤压可以与鼠标交互调整(见使用)。

Max Angle[0..+∞°]

最大角度[0. . + ∞ ° ]

If Preserve Groups (see below) is enabled, polygons that do not lie at an angle to each other in excess of this value will be held together. If the angle exceeds this value they will be torn apart during beveling.

如果启用 Preserve Groups (见下文) ，则彼此之间不成角度的多边形将被保持在一起。如果角度超过这个值，他们将被撕开在坡口。

Preserve Groups

保护群体

If enabled, connected surfaces will not be torn apart during beveling if the angle in which they lie does not exceed the Max Angle value.

如果启用，连接的表面将不会撕裂在坡口，如果其中的角度不超过最大角度值。