Cone Object

锥形物体

Basic 基础 Coord.Object 对象 Caps 帽子 Slice 切片

Cone Object

锥形物体

This command creates a cone, whose base lies in the XZ plane (but see below). The Cone object is more useful than it first appears. For example, you can quickly create a drop of water by adjusting a few parameters.

此命令创建一个锥形，其基底位于 XZ 平面(但请参见下面)。锥形物体比它最初看起来更有用。例如，您可以通过调整一些参数来快速创建一滴水。

Interactive editing

交互式编辑

The cone initially has three handles. However, note that, at first, handle 1 (for the height) and handle 3 (for the upper radius) are in the same position.

圆锥体最初有三个把手。但是，请注意，首先，句柄1(表示高度)和句柄3(表示上半径)位于同一位置。

Drag handle 1 to change the height 拖动句柄1可更改高度
Drag handle 2 to change the lower radius 拖动手柄2可更改较低的半径
Drag handle 3 to change the upper radius. 拖动手柄3可更改上半径

The handles of the cone primitive 圆锥原语的句柄

Handles 1 and 3 initially lie in the same position. Drag the handles to change the height or 句柄1和3最初位于同一位置。拖动手柄可更改高度或Shift 转移+drag the handles to change the upper radius (and thus separate the two handles at the same time). + 拖动手柄来改变上半径(从而同时分离两个手柄)

Enable the Top or Bottom rounding functions in the Caps tab. Two additional handles will be made available.

启用“大写”选项卡中的“顶部”或“底部”舍入函数。将提供两个额外的处理。

Additional handles 附加句柄

Drag the handles (4) and (5) to change the width of rounding at top and at bottom, respectively. 拖动手柄(4)和(5)可分别改变上下舍入的宽度

Drag the handles (6) and (7) to change the height of rounding at top and bottom, respectively.

拖动手柄(6)和(7)可分别改变顶部和底部的舍入高度。