Iron

铁

Iron

铁

If your mesh looks too uneven, smooth it out using this virtual iron. The tool works in all three modes (point, edge and polygon).

如果你的网格看起来太不均匀，平滑它使用这个虚拟铁。该工具工作在所有三种模式(点，边和多边形)。

The Iron tool works by smoothing out the selection in areas where the angle between neighboring edges is equal to or greater than a threshold angle (Angle). The strength of smoothing is controlled by the Percent value.

熨斗工具的工作原理是在相邻边缘之间的角度等于或大于一个阈值角度(角度)的区域平滑选择。平滑的强度由百分比值控制。

To use the Iron tool:

使用熨斗工具:

Drag in the viewport to vary the Percent value (i.e. the strength of smoothing).

拖动视区以改变百分比值(即平滑的强度)。

Shift +drag in the viewport to vary the Angle value (i.e. the threshold angle).

移动 + 拖动视窗改变角度值(即阈值角度)。