Parameter

参数

Transform

转换

Transform Mode

转换模式

Absolute

绝对

Here are several Effector-specific settings: If Absolute is selected, the clones will be arranged directly onto the spline, which is exactly what most users want.

这里有几个效果器特定的设置: 如果绝对被选中，克隆将被直接安排到样条上，这正是大多数用户想要的。

The other modes are especially then useful, if both Start and End are set to 0%. The clones will then move as shown in the image below when the Offset setting is varied:

如果开始和结束都设置为0% ，那么其他模式就特别有用。如下图所示，当偏移量设置变化时，克隆将移动:

Relative to Node

相对于 Node

Imagine a copy the spline on each clone (with its first spline segment oriented in the direction of the Z axis), which the clone follows via the Offset variation.

想象一下每个克隆上的样条副本(第一个样条段朝向 z 轴的方向) ，克隆通过偏移量变化遵循这个副本。

Relative to Spline

相对于样条曲线

Varying the Offset value will move the clones in unison, relative to the spline, without being placed onto the spline.

改变偏移量值可以相对于样条一致地移动克隆，而不需要放置在样条上。

Position

职位

Use this setting to define whether or not the Effector’s position should be varied.

使用此设置来定义是否应该改变效果器的位置。

Rotation

旋转

Use this setting to define whether or not the Effector’s rotation should be varied.

使用此设置来定义是否应该改变效果器的旋转。

R[HPB °]

R [ HPB ° ]

Activating Rotation will make the R.H, R.P and R.B settings available, with which each clone can be rotated according to its coordinate system.

激活旋转将使 R.H，R.P 和 R.B 设置可用，每个克隆可以根据其坐标系旋转。