Cylinder Object

圆柱体对象

Cylinder Object

圆柱体对象

This command creates a cylinder, whose ends (caps) are aligned parallel to the XZ plane.

此命令创建一个圆柱体，其端点(帽子)与 XZ 平面平行对齐。

Interactive editing

交互式编辑

The cylinder initially has two handles:

钢瓶最初有两个手柄:

• Drag handle 1 to change the radius 拖动手柄1可更改半径
• Drag handle 2 to change the height. 拖动句柄2可更改高度
The default handles of the cylinder primitive. 柱面原语的默认句柄

If you enable Fillet, handle 3 appears:

如果你启用鱼片，句柄3会出现:

• Drag handle 3 to change the cap fillet’s radius. 拖动手柄3可更改瓶盖圆角半径
Additional handle of the cylinder primitive. 柱面原语的附加句柄