Straighten 拉直Options 选择Tool 工具

Options

选择

Direction

方向

Select the direction in which the guides should be made taut.

选择导线应该拉紧的方向。

• Root: In the direction of the guide root segment. 根: 在导向根段的方向上

• Normal: In the direction of the surface Normals at the guide root. 正常: 在导向根处表面法线的方向上

• Along Guide: Over the length of an average guide. Extremely small kinks will be ironed out, whereby the run of the guides will, for the most part, remain unchanged. 沿导游: 超过一般导游的长度。极小的问题将得到解决，因此导游的运行，在大多数情况下，将保持不变

Strength[-100..100%]

力量[-100. . 100% ]

This setting can also be adjusted interactively using the mouse. It adjusts the strength of the effect itself.

这个设置也可以用鼠标进行交互式调整，它可以调整效果本身的强度。

Curve

曲线

Use this curve to define the straightening effect over the length of the guides. If only the top half of the guides should be straightened, set the first half of the curve to a neutral position. The bottom half of the guides will remain unchanged.

使用这条曲线来确定导轨长度上的矫直效果。如果只有导轨的上半部分应该被拉直，那么将曲线的前半部分设置为中性位置。指南的下半部分将保持不变。