Range Mapper 测距仪Preview 预览Basic 基础Inputs 投入Outputs 产出

Inputs

投入

Data Type

数据类型

Here you can define the data type for all input and output values. You can select from Float Comma (Float; whole number values (Int)) or the vector types Color, Vector2D and Vector.

在这里，您可以为所有输入和输出值定义数据类型。您可以从 Float Comma (Float; whole number values (Int))或向量类型 Color、 Vector2D 和 Vector 中进行选择。

Value[-∞..+∞]

值[-∞ . . + ∞]

This value is converted as a percentage internally to the value range between Input Min and Input Max. The resulting percent value will then be carried over to a range between Output Min and Output Max to produce the Result.

此值在内部以百分比形式转换为 Input Min 和 Input Max 之间的值范围。产生的百分比值，然后将结转到输出最小和输出最大之间的范围产生的结果。

Input Min[-∞..+∞]
Input Max[-∞..+∞]

输入 Min [-∞ . . + ∞]输入 Max [-∞ . . + ∞]

Here you can define the value range that should be applied to the Value input. Note that the Value settings that lie outside of this input range can also be applied. The percent value that is calculated internally can therefore also be negative and have a value greater than 100%. In contrast to the Range Mapper function in XPresso, an integrated clamp and modulo function are not available. Both can, if desired, be added via the Clamp and Modulo Nodes, respectively.

在这里，您可以定义应该应用于 Value 输入的值范围。请注意，也可以应用此输入范围之外的 Value 设置。因此，内部计算的百分比值也可以为负，并且大于100% 。与 XPresso 中的范围映射器功能相比，集成的钳位和模函数是不可用的。如果需要，两者都可以分别通过箝位和 Modulo Nodes 添加。

Output Min[-∞..+∞]
Output Max[-∞..+∞]

输出 Min [-∞ . . + ∞]输出 Max [-∞ . . + ∞]

Here you can define the value range that should be used for the internal calculation of the percent values between 0% and 100%. If the Value that is input lies outside of the input limit, outputs can also result that lie outside of the range defined for the output values.

在这里，您可以定义应该用于0% 到100% 之间的百分比值的内部计算的值范围。如果输入值位于输入限制之外，则输出也可能位于为输出值定义的范围之外。