Options

选择

Offset[-∞..+∞m]
Offset Variation[0..+∞%]

偏移量[-∞ . . + ∞ m ]偏移量变化[0. . + ∞% ]

Here you can change the offset of the extruded surfaces. You can also specify a Offset Variation value to vary the offset per smooth shift extrusion group.

在这里你可以改变挤压表面的偏移量。您还可以指定偏移量变化值来改变每个平滑移位挤出组的偏移量。

Preserve Groups

保护群体

Maximum Angle[0..180°]

最大角度[0. . 180 ° ]

This is the maximum angle at which surfaces may lie to each other to ensure that no additional surfaces are created with Smooth Shift. The Preserve Groups option can be used to enable or disable the entire fuctionality interactively.

这是各个表面可能相对的最大角度，以确保没有额外的表面被创建与平滑移动。可以使用 Preserve Groups 选项交互地启用或禁用整个功能。

The marked surfaces are those which had to be additionally built and inserted because the Maximum Angle was exceeded. 标记的表面是那些必须额外建立和插入，因为最大角度被超过 Quadrangles (and, in some cases, triangles also) are inserted in these critical places where the angle is exceeded, ensuring that the surfaces are not torn apart. These triangles should be avoided if you want to use an object for Subdivision Surface, otherwise the Subdivision Surface object may display uneven shading properties. 四边形(在某些情况下，还有三角形)插入到这些超过角度的关键位置，以确保表面没有被撕裂。这些三角形应该避免，如果你想使用一个对象的细分曲面，否则细分曲面对象可能显示不平衡的阴影属性

Subdivision[1..+∞]

细分[1. . + ∞]

Subdivision set to 1 (left) and 3 (right). 细分设置为1(左)和3(右)

The Subdivision value defines the number of subdivisions along the smooth shift extrusion.

细分值定义了沿着平滑移位挤压的细分数。

Create N-gons

创建 n 个图形

Enable this option if you have defined subdivisions but want to avoid the additional edges between the original polygons and the smooth shift extrusion that this would normally cause.

如果您已经定义了细分，但是希望避免原始多边形和平滑移位挤压之间的附加边缘，则启用此选项。