Options

选择

Radius[0..+∞]

半径[0. . + ∞]

This is the radius of the tool itself, within which the guides will be painted onto the surface.

这是工具本身的半径，在这个半径内，导轨将绘制在表面上。

Step[0..2147483647]

步骤[0. . 2147483647]

If you paint guides onto a surface using click & drag, this setting defines how often guides will be painted onto a surface. If this setting is given a value of 10, guides will be set every 10 pixels for each mouse movement.

如果您使用点击和拖动在表面上绘制导轨，此设置定义了导轨绘制在表面上的频率。如果这个设置的值是10，每次鼠标移动都会设置10个像素的向导。

Count[1..2147483647]

计数[1. . 2147483647]

This is the maximum number of guides that will be set per individual click or each time guides are set (Step).

这是每次单击或每次设置时间指南时设置的最大指南数(步骤)。

Length[0..+∞m]

长度[0. . + ∞ m ]

This setting defines the length of the guides that will be painted onto the surface.

此设置定义将绘制在表面上的导轨的长度。

Min Spacing[0..+∞m]

最小间距[0. . + ∞ m ]

This is the minimum distance between set guides.

这是设置指南之间的最小距离。

Interpolated

插入

If this setting is active, newly created guides will be interpolated between existing guides.

如果此设置处于活动状态，则新创建的向导将插入到现有向导之间。

Strength[0..100%]

力量[0. . 100% ]

Use this setting to adjust the degree of interpolation of the newly painted Guides. A value of 0% will result in no interpolation (Guides will stand completely perpendicular to the surface). A value of 100% will result in complete interpolation. Setting the value to 100% is not advisable since Guides could result that penetrate the surface - something that should be avoided. A value of around 70% will deliver the best results.

使用此设置来调整新绘制的指南的插值程度。一个0% 的值将导致没有插值(指南将站在完全垂直于表面)。100% 的值将导致完整的插值。将值设置为100% 是不可取的，因为指南可能会导致穿透表面——这是应该避免的。70% 左右的数值会带来最好的结果。

Pressure

压力

If you use a graphics tablet, use Pressure to define which setting (None, Radius, Length, Count) should be affected by the pen.

如果您使用图形板，使用压力来定义哪个设置(无，半径，长度，计数)应该受到笔的影响。