P Pass AB 通过 a/bBasic 基础Parameter 参数
Parameter
参数
‧ GroupA ‧ GroupB
These boxes define which particle groups the node should output. Open the Thinking Particles Settings and, from there, drag the name of one of the particle groups and drop it into the GroupA box. Drag & drop the name of the other particle group into the GroupB box.
这些框定义了节点应该输出的粒子组。打开 Thinking Particles Settings，从这里，拖动其中一个粒子组的名称，并将其放入 GroupA 框中。将其他粒子组的名称拖放到 GroupB 框中。
Choose which two groups of particles the node
should output. 选择节点应该输出的两组粒子
•
Distance Type
•
Distance[0..+∞]
距离类型•距离[0. . + ∞]
These settings allow you to check the distances between particles of the two groups. The Distance Type setting controls whether the particles will be passed to the Particle A and Particle B outputs port and if so, when they will be passed.
这些设置允许您检查两组粒子之间的距离。距离类型设置控制粒子是否将被传递到粒子 a 和粒子 b 输出端口，如果是，当他们将被传递。
没有
Distances are not checked.
距离不被检查。
室内外
Particles in groups A and B are passed to the output ports if they are closer to each other (type set to Inside) or further apart from each other (type set to Outside) than the Distance value.
如果 a 组和 b 组中的粒子彼此距离更近(类型设置为 Inside)或者彼此距离更远(类型设置为 Outside) ，则它们被传递到输出端口。
Output ports:
输出端口:
特别•特别
Connect each of these ports to the Particle input port of the two nodes that should receive the particle groups.
将这些端口中的每一个连接到应该接收粒子组的两个节点的粒子输入端口。
Particle Count A[-2147483648..2147483647]•
Particle Count B[-2147483648..2147483647]•
粒子计数 a [-2147483648. . 2147483647]•粒子计数 b [-2147483648. . 2147483647]•
The current number of particles of A and B.
A 和 b 粒子的当前数量。
Position A[XYZ ]•
Position B[XYZ ]•
位置 a [ XYZ ]•位置 b [ XYZ ]•
The positions of the particles.
粒子的位置。
向量 AB [ XYZ ]•
The vector between the particles in groups A and B.
A 组和 b 组中粒子之间的矢量。
距离 AB [-∞ . . + ∞] ·
The distance between the particles in groups A and B.
A 组和 b 组粒子之间的距离。