Parameter

参数

Type

类型

This setting controls whether the PChronometer’s time is reset to zero each time it is restarted (Type set to Reset) or continues from the time elapsed when the watch was last stopped (Type set to Sum).

这个设置控制每次重新启动时 PChronometer 的时间是重置为零(类型设置为 Reset) ，还是从手表最后一次停止时的时间持续(类型设置为 Sum)。

Time Factor[-∞..+∞%]
Variation[0..100%]

时间因素[-∞ . . + ∞% ]变化[0.100% ]

This value acts as a scaling factor for the time elapsed. By using different scaling factors for the same interval of time, you can make time appear to run at different rates for different nodes. For example, with a Time Factor of 200%, twice as much time will have elapsed as for a node that is being controlled via a Time Factor of 100%.

此值充当经过时间的缩放因子。通过在相同的时间间隔内使用不同的缩放因子，可以使时间在不同的节点上以不同的速率运行。例如，对于时间因子为200% 的节点，所花费的时间是通过时间因子为100% 控制的节点的两倍。

You can vary the Time Factor using Variation. Note that If a particle stream is connected to the node, the variation in time will be calculated for each particle.

你可以使用变化来改变时间因素。注意，如果一个粒子流连接到节点，将计算每个粒子的时间变化。

Additional input ports:

其他输入端口:

• On

•安

A Boole value of True switches the node on; a value of False switches it off.

值为 True 的 Boole 将打开该节点; 值为 False 将关闭该节点。

• Particle

•粒子

Here you can connect a particle stream. The time can then be saved per particle. This is useful for when a specific particle event — such as reaching a defined position — should trigger the timing.

在这里你可以连接一个粒子流。然后可以为每个粒子节省时间。当一个特定的粒子事件---- 比如到达一个确定的位置---- 应该触发计时时，这是很有用的。

• Animation Time

•动画时间

Since the node’s parameters can be keyframe animated, by default the Cinema 4D time is used internally to ensure that the values are interpolated correctly. However, you can pass your own time value to this port. This should be of the data type Time, which is a Real number in the simplest case. If no value is passed, Cinema 4D’s time is used.

由于节点的参数可以是关键帧动画，默认情况下 Cinema 4D 时间在内部使用，以确保值被正确插值。但是，您可以将自己的时间值传递到此端口。这应该是数据类型 Time，在最简单的情况下，它是一个实数。如果没有值传递，使用 Cinema 4D 的时间。

Output ports:

输出端口:

Time•

时间•

Outputs the stopped time in seconds. When the node is disabled, the value here will be the time value from when the watch was last stopped.

以秒为单位输出停止的时间。当节点被禁用时，这里的值将是手表上次停止时的时间值。