Clamp

夹钳

Clamp

夹钳

Using this Modifier Layer, value ranges can be clamped at their borders. Assuming you have values from 0 to 1 but want values between 0 and 8, you would set the Maximum value to 80%. Values between 0.8 and 1 will be clamped and all will be assigned a value of 0.8.

使用这个修改层，值范围可以夹在他们的边界。假设您的值从0到1，但是希望值介于0到8之间，那么您将把 Maximum 值设置为80% 。将夹住0.8到1之间的值，并将所有值分配为0.8。

Note that all Field lists themselves clamp values less than 0 and greater than 1 by default (this can, however, be disabled).

请注意，默认情况下，所有 Field 列表本身都会列出小于0和大于1的钳位值(但是，可以禁用这个值)。